• my photo

    Click photo for About Me

  • Enter your email address to subscribe to this blog and receive notifications of new posts by email.

    Join 1,021 other subscribers
  • Pinterest

    Follow Me on Pinterest
  • Amazing Deals

    Click image for Amazing Deals!

  • Share this blog

    Bookmark and Share
  • Archives

  • Categories

  • Recent Posts

  • Blog Stats

    • 402,135 hits
  • Meta

  • Disclaimer

    All content found at Stampin' by Genny is the sole responsibility of Genevieve Valdes, a Stampin’ Up! Independent Demonstrator. Stampin’ Up! does not endorse, edit, or otherwise contribute to this website.

Stampin’ Up! Vintage Skating Boot Gift Card Holder and Christmas ornament

This week at Hand Stamped Sentiments the challenge is Anything Goes Christmas Ornaments.  I love the Stampin’ Up! Holiday Stocking and Stocking Accents dies.  Inspired by the many stockings and boots I’ve seen created with these dies I made this vintage gift card holder.  I used the Snow burst textured folder for the top of the boot and heat embossed it with Iridescent embossing powder.  For the boot part I cut two Old Olive card stock stockings and two of the green print Paisley Petals DSP.  To show the green print on the back you need to flip the paper so the print you want to show both sides are showing when stacked.  I then adhered the DSP to the stockings then embossed with the Vintage Wallpaper embossing folder and Big Shot.

The blades are die cut from the Silver shimmery paper using the candy canes from the Stocking Accents die.   You need to cut four, two sets facing one side and the other facing opposite for the back side.  Therefore you need to cut two sets with the glimmer paper up and two sets with the glimmer paper down.  Before I adhered both sides of the boot I sandwiched the blades between the sides of the boot and used Tombow adhesive glue.

I then used some lace trim on the boot and adhered both cuffs to the top of the boot (it would look better if it was SU crochet trim but I ran out) .  For the lacing I made four 3/16″ holes with my Crop-a-dile then used Very Vanilla Satin Ribbon to lace up the boot.  The loop at the top is hemp twine through a  1/8″ hole.  I installed an eyelet for this hole.  I didn’t have any 3/16″ eyelets for the lace holes but it would look even better if I did.

An easy project with so many options for colors.

hand stamped sentiments christmas ornament challengeHop on over to HSS for more inspiration from our design team!

All Stampin’ Up! supplies below may be ordered from my website or email me to place your order.

All products are Stampin’ Up! unless noted.

Vintage Skater Boot Gift Card holder and Christmas ornament

Size:  7.25”  H x 5.50” W

Stamp sets: Curly Cute

Paper: Card Base:  Old Olive, Very Vanilla; DSP Paisley Petals, Silver glimmer paper

Ink: Old Olive, Versamark

Accessories: Big Shot, Snow Burst Embossing Folder, Vintage Wallpaper Embossing Folder, Holiday Stocking Die, Stocking Accents die, Very Vanilla Satin Ribbon, hemp twine, Basic Pearls, 1/8″ metal eyelet, Crop-a-dile, non-Stampin’ Up! lace trim

%d bloggers like this: